ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small
parts used in assembly. Assembly requires the included allen wrench | and your own phillips screw- | |||
driver | , two adjustable wrenchs | , and scissors | . |
1.Note that the Right Handrail and the Console Base (not shown) are connected to the treadmill by a Wire Harness. During assembly steps 1 through 5, be careful not to pull on or damage the Wire Harness.
With the help of a second person, carefully lay the treadmill on its side. Position one of the Base Legs
(38)on the base of the Upright (31) as shown. Make sure that the Base Leg Pads (41) and the Front Wheel (39) are in the indicated positions. Attach the Base Leg with two 3/8Ó x 2Ó Bolts (43), two 3/8Ó Washers (44) and two 3/8Ó Nuts (34).
Carefully turn the treadmill onto its other side. Assemble the other Base Leg (38) as described.
With the help of a second person, carefully raise the treadmill to the upright position so the Base Legs
(38)are resting flat on the floor.
2.Refer to HOW TO LOWER THE TREADMILL FOR USE on page 11. Follow the instructions in step 2 to lower the treadmill.
Without removing the tape from the Latch (18), hold the Latch against the left Upright (31) as shown. Attach the Latch to the left Upright with the four shorter Screws (24). Make sure that the Screws are tight, but do not overtighten them; if the Screws are overtightened, the Latch will not slide smoothly. After the Latch is attached, remove any visible tape.
Note: The inset drawing shows how the parts of the Latch (18) fit together.
3.Cut the plastic ties that hold the cage nuts in each Handrail (30, 32 not shown).
Position the Left Handrail (30) on the left Upright
(31).Thread a 1/4Ó x 1Ó Bolt (23) with a 1/4Ó Washer
(22)into the upper end of the left Upright and the Left Handrail. Do not tighten the Bolt yet.
Thread a 1/4Ó x 1Ó Bolt (23) with a 1/4Ó Washer (22) into the lower end of the Left Handrail (30) and the left Upright (31). Do not tighten the Bolt yet.
1 |
| 43 |
|
| 39 |
|
| 44 |
31 |
| 41 |
| 34 | 38 |
|
| |
2 |
|
|
31 |
|
|
18 |
| Spacer |
|
| Springs |
24 |
|
|
|
| Latch |
|
| Bracket |
3 |
|
|
|
| 30 |
| 23 |
|
|
| 22 |
|
| 31 |
|
| 22 |
|
| 23 |
5