Dell 9.7(0.0) manual Ip rip send version 1

Parameters

Defaults

Command Modes

Command History

Usage Information

Related Commands

1	(OPTIONAL) Enter the number 1 for RIP version 1.
2	(OPTIONAL) Enter the number 2 for RIP version 2.
RIPv1 and RIPv2
INTERFACE

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

pre- 6.2.1.1 Introduced on the E-Series.

If you want the interface to receive both versions of RIP, use the ip rip receive version 1 2 command.

ip rip send version — sets the RIP version for sending RIP traffic on an interface.

version — sets the RIP version the switch software uses.

ip rip send version

To send a specific version of RIP, set the interface. The version you set on the interface overrides the version command in ROUTER RIP mode.

S6000

Syntax	ip rip send version [1] [2]
	To return to the default value, use the no ip rip send version command.
Parameters	1	(OPTIONAL) Enter the number 1 for RIP version 1. The

default is RIP version 1.

Routing Information Protocol (RIP) 1311