Dell 9.7(0.0) manual Radius Commands, Debug radius, Ip radius source-interface

RADIUS Commands

The following RADIUS commands are supported by Dell Networking OS.

debug radius

View RADIUS transactions to assist with troubleshooting.

Syntax	debug radius
	To disable debugging of RADIUS, use the no debug radius command.
Defaults	Disabled.
Command	EXEC Privilege
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.
	The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.2.1.0 Introduced on the E-Series.

ip radius source-interface

Specify an interface’s IP address as the source IP address for RADIUS connections.

Syntax	ip radius source-interface interface
	To delete a source interface, use the no ip radius source-interface
	command.
Parameters	interface	Enter the following keywords and slot/port or number

information:

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

Security 1391