Dell 9.7(0.0) manual Router, Hop-limit maximum minimum limit

Parameters

Defaults

Command

Modes

Command

History

Related Commands

host	Enter the keyword host to set the device-role as host.
router	Enter the keyword router to set the device-role as router.

none

POLICY LIST CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.7(0.0)	Introduced on the S4810, S4820T, S5000, S6000, and
	Z9000 switches.

•ipv6 nd raguard policy policy-name — Defines the RA guard policy name and enter the RA guard policy configuration mode.

•ipv6 nd ra-guard enable — Allows you to configure the RA guard related commands.

hop-limit

Enable the verification of the advertised hop count limit. If this command is not configured, the verification process is bypassed.

Syntax	hop-limit {maximum minimum limit}
	To reset the hop count limit, use the no hop-limit {maximum minimum
	limit} command.

Parameters

Defaults

Command

Modes

Command

History

maximum limit Enter the keyword maximum then the hop limit value. The range is from 0 to 254.

minimum limit Enter the keyword minimum then the hop limit value. The range is from 0 to 254.

none

POLICY LIST CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

1024 Neighbor Discovery Protocol (NDP)