Dell 9.7(0.0) manual Buffer-stats-snapshot, Bandwidth-percentage percentage

bandwidth-percentage

Assign a percentage of weight to the class/queue.

S6000

Syntax bandwidth-percentage percentage

Parameters

Defaults

Command Modes

Command History

Usage Information

Related Commands

To remove the bandwidth percentage, use the no bandwidth-percentagecommand.

percentage	Enter the percentage assignment of bandwidth to the class/
	queue. The range is from 1 to 100% (granularity 1%).

none

CONFIGURATION (conf-qos-policy-out)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.1.9.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

6.2.1.1Introduced on the E-Series.

The unit of bandwidth percentage is 1%. If the sum of the bandwidth percentages given to all eight classes exceeds 100%, the bandwidth percentage automatically scales down to 100%.

qos-policy-output — creates a QoS output policy.

buffer-stats-snapshot

Enable the buffer statistics tracking utility and enter the Buffer Statistics Snapshot configuration mode. You must enable this utility to be able to configure the parameters for buffer statistics tracking. This utility is supported on the S6000 platform.

1254 Quality of Service (QoS)