VersionDescription

8.3.7.0Introduced on the S4810.

8.3.1.0Introduced.

Usage

In Dell Networking OS versions prior to 8.3.1.0, if a gratuitous ARP is received some

Information

time after an ARP request is sent, only RP2 installs the ARP information. For

 

example:

 

1.

At time t=0, Dell Networking OS sends an ARP request for IP A.B.C.D.

 

2.

At time t=1, Dell Networking OS receives an ARP request for IP A.B.C.D.

 

3.

At time t=2, Dell Networking OS installs an ARP entry for A.B.C.D only on RP2.

Beginning with Dell Networking OS version 8.3.1.0, when a gratuitous ARP is received, Dell Networking OS installs an ARP entry on all three CPUs.

arp max-entries

Enables you to configure the maximum number of ARP entries per VRF that are allowed for IPv4..

Syntax

Parameters

Defaults

Command Modes

Command History

arp max-entries [vrf vrf-name] max-number

vrf vrf-name

Enter the name of a specific VRF for which you want to

 

configure maximum number of ARP entries that IPv4 allows.

max-number

Enter the maximum number of ARP entries that a VRF RTM

 

can hold. The range is from 0 to 65535.

Not configured.

 

CONFIGURATION

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.4.(0.0)

Introduced on the S4810 and S4820T.

IPv4 Routing

745

Page 745
Image 745
Dell 9.7(0.0) manual Arp max-entries vrf vrf-name max-number, Max-number