dcb-map

Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on Ethernet ports that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.

S6000

Syntax

dcb-map map-name

 

Parameters

map-name

Enter a DCB map name. The maximum number of

 

 

 

alphanumeric characters is 32.

Defaults

Command Modes

Command History

None. There are no pre-configured PFC and ETS settings on S5000 Ethernet interfaces.

CONFIGURATION

INTERFACE

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.3(0.0)

Introduced on the S4810 and S6000 platforms.

Usage Information

A DCB map is a template used to configure DCB parameters and apply them on converged Ethernet interfaces. DCB parameters include priority-based flow control (PFC) and enhanced traffic selection (ETS).

To display the PFC and ETS settings in DCB maps, enter the show qos dcb-mapcommand.

Use the dcb-mapcommand to create a DCB map to specify PFC and ETS settings and apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC and ETS settings in the map are applied when the Ethernet port is enabled. DCBx is enabled on Ethernet ports by default.

The dcb-mapcommand is supported only on physical Ethernet interfaces.

To remove a DCB map from an interface, enter the no dcb-mapmap-namecommand in Interface configuration mode.

500

Data Center Bridging (DCB)

Page 500
Image 500
Dell 9.7(0.0) manual Dcb-map map-name, Alphanumeric characters is