Defaults

Command Modes

Command History

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword

 

fortyGigE then the slot/port information.

 

• For a Loopback interface, enter the keyword loopback

 

then a number from 0 to 16383.

 

• For a Port Channel interface, enter the keywords port-

 

channel then a number. The range is from 1 to 128.

in out both

Enter the keyword in, out, or both to debug incoming

 

interfaces, outgoing interfaces, or both incoming and

 

outgoing interfaces.

vlan vlan-id

Enter the keyword vlan then the VLAN ID. The range is from

 

1 to 4094.

count value

Enter the keyword count then the number of debug

 

outputs. The range is from 1 to 100.

Debug disabled.

 

EXEC Privilege

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

8.3.7.0Introduced on the S4810.

8.2.1.0Introduced on the C-Series, E-Series, and E-Series ExaScale.

7.4.1.0Introduced

protocol-tunnel

Enable protocol tunneling on a stacked (Q-in-Q) VLAN for specified protocol packets.

Syntax

protocol-tunnel {rate-limit rate stp}

Service Provider Bridging

1457

Page 1457
Image 1457
Dell 9.7(0.0) manual Out both, Protocol-tunnel rate-limit rate stp