Dell 9.7(0.0) manual Logging source-interface interface, Source-interface command

logging source-interface

Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog server.

Syntax	logging source-interface interface
	To disable this command and return to the default setting, use the no logging
	source-interface command.

Parameters	Enter the following keywords and slot/port or number
interface
	information:

Defaults

Command Modes

Command History

•For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

•For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

•For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.

•For the Management interface on the stack-unit, enter the keyword ManagementEthernet then the slot/port information. The slot range is from 0 to 1. The port range is 0.

•For a port channel interface, enter the keywords port- channel then a number. The range is from 1 to 128.

•For a Null interface, enter the keyword null then the Null interface number.

•For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Not configured.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.2(0.0)	Introduced on the M I/O Aggregator. This command is
	supported in Programmable-Mux (PMUX) mode only.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

Simple Network Management Protocol (SNMP) and Syslog 1515