Dell 9.7(0.0) manual Ip control-plane egress-filter, Show ip accounting access-list, Name Camcount

Related Commands

NOTE: This command supports Loopback interfaces EE3 and EF series route processor modules (RPMs). This command does not support Loopback interfaces ED series RPMs and S-Series Loopback interfaces.

NOTE: If you apply outbound(egress) IP acl on a switch port, the filter applies only for routed traffic egressing out of that port.

To associate an access-list to a non-default VRF, use the vrf attribute of this command. You can use this command at the interface context (physical/LAG) to apply the access-list to a range of VRFs.

The VRF MODE is not available for the default and management VRFs.

ip access-list standard — configures a standard ACL.

ip access-list extended — configures an extended ACL.

ip control-plane egress-filter

Enable egress Layer 3 ACL lookup for IPv4 CPU traffic.

Syntax

Defaults

Command Modes

Command History

ip control-plane egress-filter

Not enabled.

EXEC Privilege

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

show ip accounting access-list

Display the IP access-lists created on the switch and the sequence of filters.

Syntaxshow ip accounting {access-list access-list-name cam_count}

interface interface [vrf vrf-name]

Parameters	Enter the name of the ACL to be displayed.
access-list-
name
cam_count	List the count of the CAM rules for this ACL.
interface	Enter the keyword interface then the one of the following
interface	keywords and slot/port or number information:

188 Access Control Lists (ACL)