Usage Information

Related Commands

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.3.1.0Introduced for the E-Series.

This command disables the incrementing of the hops field when boot requests are relayed to a DHCP server through Dell Networking OS. If the incoming boot request already has a non-zero hops field, the message is relayed with the same value for hops. However, the message is discarded if the hops field exceeds 16, to comply with the relay agent behavior specified in RFC 1542.

ip helper-address — specifies the destination broadcast or host address for DHCP server requests.

show running-config — displays the current configuration and changes from the default values.

ip host

Assign a name and an IP address to the host-to-IP address mapping table.

S6000

Syntax

ip host name ip-address

 

To remove an IP host, use the no ip host name [ip-address]command.

Parameters

name

Enter a text string to associate with one IP address.

 

 

ip address

Enter an IP address, in dotted decimal format, to be mapped

 

 

to the name.

Defaults

Not configured.

 

Command

CONFIGURATION

 

Modes

 

 

IPv4 Routing

767

Page 767
Image 767
Dell 9.7(0.0) manual Ip host name ip-address, Ip address