Dell 9.7(0.0) manual Snmp-server user, Remote ip

Version	Description
8.3.19.0	Introduced on the S4820T.
8.3.11.1	Introduced on the Z9000.
8.3.7.0	Introduced on the S4810.
8.5.1.0	Added support for 4-port 40G line cards on ExaScale.
7.6.1.0	Introduced on the S-Series.
7.5.1.0	Introduced on the C-Series.
E-Series legacy
command

Usage	To enable this snmp-servertrap-sourcecommand, configure an IP address
Information	on the interface and enable the interface configured as an SNMP trap source.
Related	snmp-server community — sets the community string.
Commands

snmp-server user

Configure a new user to an SNMP group.

Syntaxsnmp-server user name {group_name remote ip-addressvrf vrf- name udp-port port-number} [1 2c 3] [encrypted] [auth {md5

sha} auth-password] [priv {des56 aes128} priv password] [access access-list-name ipv6 access-list-name access-list- name ipv6 access-list-name]

To remove a user from the SNMP group, use the no snmp-server user name {group_name remote ip-addressvrf vrf-nameudp-portport- number} [1 2c 3] [encrypted] [auth {md5 sha} auth- password] [priv {des56 aes128} priv password] [access access- list-name ipv6 access-list-nameaccess-list-nameipv6 access-list-name]command.

Parameters	Enter the name of the user (not to exceed 20 characters), on
name
	the host that connects to the agent.
group_name	Enter a text string (up to 20 characters long) as the name of
	the group. The following groups are created for mapping to
	read/write community/security-names (defaults):
	• v1v2creadu — maps to a community with ro
	permissions.
	• 1v2cwriteu — maps to a community rw permissions.
remote ip-	Enter the keywords udp-portthen the user datagram
address	protocol (UDP) port number on the remote device. The
	range is from 0 to 65535. The default is 162.

1494 Simple Network Management Protocol (SNMP) and Syslog