Dell 9.7(0.0) Deny for Standard IP ACLs, Example Related Commands VersionDescription Pre-6.1.1.0

Example

Related Commands

VersionDescription

pre-6.1.1.0 Introduced on the E-Series.

Dell#show route-map

route-map firpo, permit, sequence 10 Match clauses:

Set clauses: tag 34

Dell#

route-map — configures a route map.

deny (for Standard IP ACLs)

To drop packets with a certain IP address, configure a filter.

Syntaxdeny {source any host {ip-address}}[count [byte]] [dscp value] [order] [fragments] [log [interval minutes] [threshold- in-msgs [count]] [monitor]

To remove this filter, you have two choices:

•Use the no seq sequence-numbercommand if you know the filter’s sequence number.

•Use the no deny {source [mask] any host ip-address} command.

Parameters

Defaults

log	(OPTIONAL) Enter the keyword log to enable the triggering
	of ACL log messages.
threshold-in	(OPTIONAL) Enter the threshold-in-msgskeyword
msgs count	followed by a value to indicate the maximum number of ACL
	logs that can be generated, exceeding which the generation
	of ACL logs is terminated. with the seq, permit, or deny
	commands. The threshold range is from 1 to 100.
interval	(OPTIONAL) Enter the keyword interval followed by the
minutes	time period in minutes at which ACL logs must be generated.
	The time interval range is from 1 to 10 minutes.
monitor	(OPTIONAL) Enter the keyword monitor when the rule is
	describing the traffic that you want to monitor and the ACL
	in which you are creating the rule is applied to the monitored
	interface.

By default, 10 ACL logs are generated if you do not specify the threshold explicitly.

The default frequency at which ACL logs are generated is five minutes. By default, flow-based monitoring is not enabled.

Access Control Lists (ACL) 271