Dell 9.7(0.0) manual Tunnel destination ip-address ipv6-address

Command Modes

Command History

Usage Information

INTERFACE TUNNEL (conf-if-tu)

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.3(0.0)	Introduced on the S6000, S4810, S4820T, Z9000.

A value of 0 copies the inner packet hop limit (ipv6) or time-to-live (ipv4) in the encapsulated packet to the tunnel header hop limit (ipv6) or time-to-live (ipv4) value.

tunnel destination

Set a destination endpoint for the tunnel.

Syntax	tunnel destination {ip-address ipv6–address}
	To delete a tunnel destination address, use the no tunnel destination {ip-
	address ipv6–address}command.

Parameters

Defaults

Command Modes

Command History

Usage Information

ip-address Enter the destination IPv4 address for the tunnel.

ipv6–addressEnter the destination IPv6 address for the tunnel.

none

INTERFACE TUNNEL (conf-if-tu)

Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.3(0.0)	Introduced on the S4810, S4820T, S6000 and Z9000.

The tunnel interface is inoperable without a valid tunnel destination address for the configured Tunnel mode.

To establish a logical tunnel to the particular destination address, use the destination address of the outer tunnel header. If you configure a tunnel interface or source address, the tunnel destination must be compatible.

Tunneling 1591