clear ip fib stack-unit
Clear all FIB entries in the specified stack unit (use this command with caution, refer to Usage
Information.)
Syntax clear ip fib stack-unit unit-number vrf vrf-name
Parameters unit-number Enter the number of the stack unit. The range is from 0 to 11.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
clear all FIB entries corresponding to that VRF.
Command
Modes
EXEC Privilege
Command
History This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.19.0 Introduced on the S4820T.
Usage
Information
To clear Layer 3 CAM inconsistencies, use this command.
CAUTION: Executing this command causes traffic disruption.
Related
Commands
show ip fib stack-unit — shows FIB entries on a specified stack-unit.
clear ip route
Clear one or all routes in the routing table.
S6000
Syntax clear ip route [vrf vrf-name] {* | ip-address mask}
Parameters vrf vrf-name (Optional) Enter the keyword vrf and then the name of the
VRF to clear the routes corresponding to that VRF.
750 IPv4 Routing