Usage Information

Related Commands

Join Timer — Join messages announce the willingness to register some attributes with other participants. For reliability, each GARP application entity sends a Join message twice and uses a join timer to set the sending interval.

Leave Timer — Leave announces the willingness to de-register with other participants. Together with Join, Leave messages help GARP participants complete attribute reregistration and de-registration. The leave timer starts after receipt of a leave message sent for de-registering some attribute information. If a Join message is not received before the Leave time expires, the GARP application entity removes the attribute information as requested.

Leave All Timer — The Leave All timer starts when a GARP application entity starts. When this timer expires, the entity sends a Leave-allmessage so that other entities can reregister their attribute information. Then the Leave-alltime begins again.

show garp timers — displays the current GARP times.

gvrp enable

Enable GVRP on physical interfaces and LAGs.

S6000

Syntax

gvrp enable

 

To disable GVRP on the interface, use the no gvrp enable command.

Defaults

Disabled.

Command

CONFIGURATION-INTERFACE

Modes

 

Command

This guide is platform-specific. For command information about other platforms,

History

refer to the relevant Dell Networking OS Command Line Reference Guide.

 

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on C-Series, E-Series, and S-Series

628

GARP VLAN Registration (GVRP)

Page 628
Image 628
Dell 9.7(0.0) manual Gvrp enable