Dell 9.7(0.0) manual Ip igmp ssm-map, Ip igmp vrf vrf-name ssm-map std-access-list source-address

Defaults	10 seconds
Command	INTERFACE
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.
	The following is a list of the Dell Networking OS version history for this command.
	Version	Description
	9.7(0.0)	Introduced on the S6000-ON.
	9.5(0.0)	Introduced on the Z9500.
	9.2(0.0)	Introduced on the M I/O Aggregator. This command is
		supported in Programmable-Mux (PMUX) mode only.
	9.0.2.0	Introduced on the S6000.
	8.3.19.0	Introduced on the S4820T.
	8.3.11.1	Introduced on the Z9000.
	8.3.7.0	Introduced on the S4810.
	7.6.1.0	Introduced on the S-Series.
	7.5.1.0	Introduced on the C-Series.

7.6.1.0Introduced on the S-Series in Interface VLAN mode only to enable the system to act as an IGMP Proxy Querier.

7.5.1.0Introduced on the C-Series in Interface VLAN mode only to enable the system to act as an IGMP Proxy Querier.

E-Series legacy command.

ip igmp ssm-map

To translate (*,G) memberships to (S,G) memberships, use a statically configured list.

S6000

Syntax	ip igmp [vrf vrf-name]ssm-mapstd-access-list source-address
	Undo this configuration, that is, remove SSM map (S,G) states and replace them
	with (*,G) state, use the ip igmp [vrf vrf-name]ssm-mapstd-access-
	list source-address command.
Parameters	vrf vrf-name	(OPTIONAL) Enter the keyword vrf followed by the name of

the VRF to configure this setting on that VRF.

NOTE: Applies to specific VRF if input is provided, else applies to Default VRF.

Internet Group Management Protocol (IGMP) 645