Dell 9.7(0.0) Interface group, Tengigabitethernet 1/1 5 interface group, Tengigabitethernet 1/1-5

interface group

Create or delete group of VLANs with a single command. You can also use this command to apply a set of configurations on a group of interfaces.

S6000

Syntax

Parameters

Command Modes

Command History

interface group [fortyGigE slot/port { - port } tengigabitethernet slot/port { - port } vlan vlanid {- vlanid } ]

To delete a range of VLANs, use the following command: no interface group

vlan vlanid {- vlanid}

interface,	Enter the keywords interface group and one of the
interface,...
	interfaces — slot/port or VLAN number. Select the range of
	interfaces for bulk configuration. Spaces are not required
	between the commas. Comma-separated ranges can
	include VLANs and physical interfaces.
	Enter the member VLANs using VLAN IDs (separated by
	commas), a range of VLAN IDs (separated by a hyphen), a
	single VLAN ID, or a combination. For example: VLAN IDs
	(comma-separated): 3, 4, 6. Range (hyphen-separated):
	5-10.
	Slot/Port information need not contain a space before and
	after the dash. For example. both of the following
	commands are valid: interface group
	tengigabitethernet 1/1 - 5 ; interface group
	tengigabitethernet 1/1-5; ; .
	• For a 10-Gigabit Ethernet interface, enter the keyword
	TenGigabitEthernet then the slot/port information.
	• For a 40-Gigabit Ethernet interface, enter the keyword
	fortyGigE then the slot/port information.
	• For a VLAN interface, enter the keyword vlan then a
	number from 1 to 4094.
CONFIGURATION
Version	Description
9.7(0.0)	Introduced on the S6000-ON.
9.4(0.0)	Introduced on the S4810, S4820T, S6000, Z9000, and MXL
	Switch.

676 Interfaces