Dell 9.7(0.0) manual Configuration conf-rstp

tc-flush-standard

Enable the MAC address flushing after receiving every topology change notification.

Syntax	tc-flush-standard
	To disable, use the no tc-flush-standardcommand.
Defaults	Disabled
Command	CONFIGURATION (conf-rstp)
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.
	The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

6.5.1.0Introduced on the E-Series.

Usage	By default, Dell Networking OS implements an optimized flush mechanism for
Information	RSTP. This implementation helps in flushing MAC addresses only when necessary
	(and less often), allowing for faster convergence during topology changes.
	However, if a standards-based flush mechanism is needed, you can turn on this
	knob command to enable flushing MAC addresses after receiving every topology
	change notification.

Rapid Spanning Tree Protocol (RSTP) 1359