Dell 9.7(0.0) manual Stack-unit stack-group, Syntaxstack-unit unit-idstack-group stack-group-id

Related Commands

VersionDescription

8.3.7.0Introduced on the S4810.

8.3.11.1Introduced on the Z9000.

•reload – reboots Dell Networking OS.

•show system (S-Series and Z-Series) – displays the status of all stack members or a specific member.

stack-unit stack-group

Configure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure the unit is assigned to the correct group.

Syntaxstack-unit unit-idstack-group stack-group-id

Parameters

Defaults

Command Modes

Command History

Usage Information

To remove the current stack group configuration, use the no stack-unitunit- id stack-groupstack-idcommand.

unit-id Enter the stack unit ID.

stack-group-idEnter the stack group ID. The range is from 0 to 31.

none

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.7.1Introduced on the S4810.

8.3.12.0Reset command mode from EXEC to CONFIGURATION.

The following message displays to confirm the command.

Setting ports Fo 1/60 as stack group will make their interface configs obsolete after a reload.[confirm yes/no]: If “y” is entered, all non-default configurations on any member ports of the current stack group will be removed when the unit is rebooted.

1538 Stacking