Dell 9.7(0.0) manual Deny icmp, Related Commands

Related Commands

When you use the log option, the CP processor logs detail the packets that match. Depending on how many packets match the log entry and at what rate, the CP may become busy as it has to log these packets’ details.

The monitor option is relevant in the context of flow-based monitoring only. For more information, refer to the Port Monitoring chapter.

The C-Series and S-Series cannot count both packets and bytes, when you enter the count byte options, only bytes are incremented.

NOTE: When you configure ACL logging and byte counters simultaneously, byte counters may display an incorrect value. Configure packet counters with logging instead.

deny tcp — assigns a filter to deny TCP packets.

deny udp — assigns a filter to deny UDP packets.

ip access-list extended — creates an extended ACL.

deny icmp

To drop all or specific internet control message protocol (ICMP) messages, configure a filter.

Syntaxdeny icmp {source mask any host ip-address} {destination mask any host ip-address} [dscp] [count [byte] [order] [fragments]

To remove this filter, you have two choices:

•Use the no seq sequence-numbercommand if you know the filter’s sequence number.

•Use the no deny icmp {source mask any host ip-address} {destination mask any host ip-address} command.

Parameters	Enter the IP address of the network or host from which the
source
	packets were sent.
mask	Enter a network mask in /prefix format (/x) or A.B.C.D. The
	mask, when specified in A.B.C.D format, may be either
	contiguous or non-contiguous.
any	Enter the keyword any to specify that all routes are subject
	to the filter.
host ip-address	Enter the keyword host then the IP address to specify a host
	IP address.
destination	Enter the IP address of the network or host to which the
	packets are sent.
dscp	Enter this keyword dscp to deny a packet based on the
	DSCP value. The range is from 0 to 63.

200 Access Control Lists (ACL)