Dell 9.7(0.0) manual File Management, Boot system

3

File Management

This chapter contains command line interface (CLI) commands needed to manage the configuration files as well as other file management commands.

boot system

Tell the system where to access the Dell Networking OS image used to boot the system.

Syntaxboot system {gateway ip address stack-unit [{0-11 0-7] all] [default primary {system {A: B: bmp-boot} tftp: secondary]}

To return to the default boot sequence, use the no boot system command.

Parameters	gateway	Enter the IP address of the default next-hop gateway for the
		management subnet.
	ip-address	Enter an IP address in dotted decimal format.
	stack-unit	Enter the stack-unit number for the master switch.
	0-11, 0-7, all	Enter the stack-unit number.
	default	Enter the keyword default to use the primary Dell
		Networking OS image.
	primary	Enter the keyword primary to use the primary Dell
		Networking OS image.
	secondary	Enter the keyword secondary to use the primary Dell
		Networking OS image.
	tftp:	Enter the keyword TFTP: to retrieve the image from a TFTP
		server. tftp://hostip/filepath.
	A: B:	Enter A: or B: to boot one of the system partitions.
	bmp-boot	Enter the keyword bmp-bootto boot the system, when the
		you are not sure about the partition that contains image
		from DHCP offer.
		NOTE: In normal-reload, this keyword is not enabled.
Defaults	Not configured.

58 File Management