Dell 9.7(0.0) manual IPv4 Routing, Arp

23

IPv4 Routing

The basic IPv4 commands are supported by Dell Networking operating system on the S6000 platform.

arp

To associate an IP address with a MAC address in the switch, use address resolution protocol (ARP).

S6000

Syntax	arp [vrf vrf-name]ip-address mac-address interface
	To remove an ARP address, use the no arp ip-addresscommand.
Parameters	vrf vrf-name	Enter a VRF name to configure an ARP entry for that VRF.
		Use the VRF option after the keyword arp to configure a
		static arp on that particular VRF.
	ip-address	Enter an IP address in dotted decimal format.
	mac-address	Enter a MAC address in nnnn.nnnn.nnnn format.
	interface	(OPTIONAL) Enter any of the following keywords and slot/
		port or number information:
		• For a 10-Gigabit Ethernet interface, enter the keyword
		TenGigabitEthernet then the slot/port information.
		• For a 40-Gigabit Ethernet interface, enter the keyword
		fortyGigE then the slot/port information.
		• For the Management interface on the stack-unit, enter
		the keyword ManagementEthernet then the slot/port
		information. The slot range is from 0 to 1. The port range
		is 0.
		• For a port channel interface, enter the keywords port-
		channel then a number. The range is from 1 to 128.
Defaults	Not configured.
Command	CONFIGURATION
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.

742 IPv4 Routing