show ip bgp dampened-paths

View BGP routes that are dampened (non-active).

S6000

Syntax

Parameters

Command Modes

Command History

show ip bgp [vrf vrf-name] [ipv4 {multicast unicast} ipv6 unicast] dampened-paths

vrf vrf-name

(OPTIONAL) Enter the keywords vrf and then the name of

 

the VRF to view routes that are affected by a specific

 

community list corresponding to that VRF.

ipv4 multicast

(OPTIONAL) Enter the keyword ipv4 followed by the

 

keyword multicast to view information related only to ipv4

 

multicast routes.

ipv4 unicast

(OPTIONAL) Enter the keywords ipv4 followed by the

 

keyword unicast to view information related only to ipv4

 

unicast routes.

ipv6 unicast

(OPTIONAL) Enter the keyword ipv6 followed by the

 

keyword unicast to view information related only to ipv6

 

unicast routes.

•EXEC

•EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Usage Information

Version

Description

9.7(0.0)

Added the ipv4 multicast and ipv6 unicast parameters.

9.4(0.0)

Added support for VRF.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

To determine a BGP session flap, both a route-down event and a subsequent route-up event corresponding to a single route are considered. As a result, a flap

Border Gateway Protocol

457

Page 457
Image 457
Dell 9.7(0.0) manual 457