Dell 9.7(0.0) manual Advertise med guest-voice-signaling, DSCPvalue priority-tagged number

Command Modes

Command History

Related Commands

CONFIGURATION (conf-lldp)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.7.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series and E-Series.

protocol lldp (Configuration) — enables LLDP globally.

debug lldp interface — debugs LLDP.

show lldp neighbors — displays the LLDP neighbors.

advertise med guest-voice-signaling

To advertise a separate limited voice service for a guest user when the guest voice control packets use a separate network policy than the voice data, configure the system.

S6000

Syntax	advertise med guest-voice-signaling {vlan-id layer2_priority
	DSCP_value} {priority-tagged number}
	To return to the default, use the no advertise med guest-voice-signaling
	{vlan-id layer2_priority DSCP_value} {priority-taggednumber}
	command.
Parameters	vlan-id	Enter the VLAN ID. The range is from 1 to 4094.
	layer2_priority	Enter the Layer 2 priority. The range is from 0 to 7.
	DSCP_value	Enter the DSCP value. The range is from 0 to 63.
	priority-tagged	Enter the keywords priority-taggedthen the Layer 2
	number	priority. The range is from 0 to 7.
Defaults	unconfigured.

966 Link Layer Discovery Protocol (LLDP)