Defaults

none

 

Command

REDIRECT-LIST

 

Modes

 

 

Command

Version

Description

History

 

 

 

9.7(0.0)

Introduced on the S6000-ON.

 

9.4(0.0)

Introduced on the S4810, S4820T, S6000, and Z9000.

 

8.4.2.1

Introduced on the C-Series and S-Series.

 

8.4.2.0

Introduced on the E-Series Tera Scale.

 

7.7.1.0

Introduced on the E-Series ExaScale.

redirect

Configure a rule for the redirect list.

S6000

Syntaxredirect {ip-address slot/port} tunnel tunnel-id}[track<obj-id>]{ip-protocol-number protocol-type [bit]} {source mask any host ip-address} {destination mask any host ip-address} [operator]

To remove this filter, use one of the following:

•Use the no seq sequence-numbercommand if you know the filter’s sequence number.

•You can also use the no redirect {ip-address slot/port} tunnel tunnel-id}[track<obj-id>]{ip-protocol-number [bit] protocol-type} {source mask any host ip-address} {destination mask any host ip-address} [operator] command.

Parameters

Enter the keyword redirect to assign the sequence to the

redirect

 

redirect list.

ip-address

Enter the IP address of the forwarding router.

slot/port

Enter the keyword slot / port followed by the slot/port

 

information.

tunnel

Enter the keyword tunnel to configure the tunnel setting.

tunnel-id

Enter the keyword tunnel-idto redirect the traffic.

track

Enter the keyword track to enable the tracking.

track <obj-id>

Enter the keyword track <obj-id>to track object-id.

1180

Policy-based Routing (PBR)

Page 1180
Image 1180
Dell 9.7(0.0) manual Redirect, Tunnel-id, Track obj-id