Dell 9.7(0.0) manual Command Modes Command History Usage Information Ipv4 unicast, Cluster-id

Command Modes

Command History

Usage Information

ipv4 unicast	(OPTIONAL) Enter the keyword ipv4 followed by the
	keyword unicast to view information related only to ipv4
	multicast routes.
ipv6 unicast	(OPTIONAL) Enter the keyword ipv6 followed by the
	keyword unicast to view information related to only to the
	ipv6 unicast routes.
cluster-id	(OPTIONAL) Enter the cluster id in dotted decimal format.
	The range is 1 — 4294967295.

•EXEC

•EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version	Description
9.7(0.0)	Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0)	Added support for VRF.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

The following describes the show ip bgp cluster-listcommand shown in the following example.

Field	Description
Network	Displays the destination network prefix of each BGP route.
Next Hop	Displays the next hop address of the BGP router. If 0.0.0.0 is
	listed in this column, then local routes exist in the routing
	table.
Metric	Displays the BGP route’s metric, if assigned.
LocPrf	Displays the BGP LOCAL_PREF attribute for the route.
Weight	Displays the route’s weight.
Path	Lists all the ASs the route passed through to reach the
	destination network.

Border Gateway Protocol 419