POLICY-OUT mode supersedes the service-class bandwidth-percentage command.

service-class dot1p-mapping

Configure a service-class criterion based on a dot1p value.

S6000

Syntax

service-class dot1p-mapping {dot1p0 queue dot1p1 queue

 

dot1p2 queue dot1p3 queue dot1p4 queue dot1p5 queue

 

dot1p6 queue dot1p7 queue}

Parameters

queue

Enter a value from 0 to 7.

 

Defaults

For each dot1p Priority, the default CoS queue value is:

 

• Dot1p Priority : 0 1 2 3 4 5 6 7

 

• Queue : 2 0 1 3 4 5 6 7

Command Modes

Command History

Usage Information

Related Commands

CONFIGURATION

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

To apply dot1p-queue-mapping, use the service-class dynamic dot1p command.

show qos dot1p-queue-mapping — displays the dot1p priority to queue mapping on the switch.

show qos dot1p-queue-mapping

Displays the dot1p priority to queue mapping on the switch.

S6000

Syntax

show qos dot1p-queue-mapping

Quality of Service (QoS)

1247

Page 1247
Image 1247
Dell 9.7(0.0) manual Service-class dot1p-mapping, Show qos dot1p-queue-mapping, Parameters Queue