Dell 9.7(0.0) manual Snmp-server host, Ip-address

Usage Information

Example

Related Commands

VersionDescription

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

E-Series legacy command

The following Example specifies the group named harig as a version 3 user requiring both authentication and encryption and read access limited to the read named rview.

NOTE: The number of configurable groups is limited to 16 groups.

Dell#conf

Dell(conf)# snmp-server group harig 3 priv read rview Dell#

show snmp group — displays the group name, security model, view status, and storage type of each group.

show running-config — displays the SNMP running configuration.

snmp-server host

Configure the recipient of an SNMP trap operation.

Syntaxsnmp-server host ip-address ipv6-address[vrf vrf-name] traps informs [version 1 2c 3] [auth no auth priv] [community-string] [udp-port port-number] [notification-type] To remove the SNMP host, use the no snmp-server host ip-address[vrf vrf-name] traps informs [version 1 2c 3] [auth noauth priv] [community-string] [udp-port number] [notification-type] command.

Parameters	Enter the keyword host then the IP address of the host
ip-address
	(configurable hosts is limited to 16).
ipv6-address	Enter the keyword host then the IPv6 address of the host in
	the x:x:x:x::x format.
	NOTE: The :: notation specifies successive hexadecimal
	fields of zero.
vrf vrf-name	Enter the keyword vrf and then the name of the VRF that
	the SNMP server uses to connect to the host.

1488 Simple Network Management Protocol (SNMP) and Syslog