Parameters

Defaults

Command Modes

Command History

Usage Information

To disable broadcast rate-limiting, use the storm-control broadcast [percentage decimal_value in out] [wred-profile name]] [packets_per_second in] command.

percentagedeci

Enter the percentage of broadcast traffic allowed in or out of

mal_value in

the network. Optionally, you can designate a decimal value

out

percentage, for example, 55.5%. The decimal range is from .1

 

to .9.

wred-profile

Enter the keyword wred-profile followed by the profile

name

name to designate a wred-profile.

packets_per_se

Enter the packets per second of broadcast traffic allowed

cond in

into the network. The range is from 0 to 33554368.

none

CONFIGURATION (conf)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.2(0.0)

Introduced on the M I/O Aggregator. This command is

 

supported in Programmable-Mux (PMUX) mode only.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

7.4.1.0E-Series Only: Added the percentage decimal value option.

6.5.1.0Introduced on the E-Series.

Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast traffic is treated as unknown-unicast traffic.

Storm Control

1545

Page 1545
Image 1545
Dell 9.7(0.0) manual Percentagedeci, Malvalue, Packetsperse, Cond