Dell 9.7(0.0) Debug ip bgp soft-reconfiguration, VersionDescription 70.0 Added support for VRF

Usage	To remove all configured debug commands for BGP, enter the no debug ip bgp
Information
	command.

debug ip bgp soft-reconfiguration

Enable soft-reconfiguration debug.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

debug ip bgp [vrf vrf-name] [A.B.C.D X:X:X:X::X peer-group-

name] soft-reconfiguration

To disable, use the debug ip bgp [vrf vrf-name] [A.B.C.D X:X:X:X::X peer-group-name] soft-reconfiguration command.

vrf vrf-name	(OPTIONAL) Enter the keyword vrf followed by the name of
	the VRF to enable soft-reconfiguration debugging on that
	VRF.
A.B.C.D	(OPTIONAL) Enter the IPv4 address of the neighbor in dotted
	decimal format.
X:X:X:X::X	(OPTIONAL) Enter an IPv6 address.
peer-group-	(OPTIONAL) Enter the name of the peer group to disable or
name	enable all routers within the peer group..
Disabled
EXEC Privilege

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Added support for VRF.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

7.2.1.0Introduced.

374 Border Gateway Protocol