Defaults

Command

Modes

Command

History

Usage

Information

redistribute

•For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Enabled, that is sending of routing updates are enabled by default.

ROUTER OSPF for OSPFv2

ROUTER OSPFv3 for OSPFv3

VersionDescription

9.1.(0.0)

Introduced support for OSPFv3 on the S4810 and Z9000.

8.3.19.0Introduced on the S4820T.

7.8.1.0Added support for the C-Series.

7.4.1.0Introduced on the E-Series.

By default, no interfaces are passive. Routing updates are sent to all interfaces on which the routing protocol is enabled.

If you disable the sending of routing updates on an interface, the particular address prefix continues to be advertised to other interfaces, and updates from other routers on that interface continue to be received and processed.

OSPFv3 for IPv6 routing information is not sent or received through the specified router interface. The specified interface address appears as a stub network in the OSPFv3 for IPv6 domain.

On configuring suppression using the passive-interface command, the state of the OSPF neighbor does not change to INIT; instead, the state of the OSPF neighbor changes to DOWN after the dead-timer expires.

Redistribute into OSPFv3.

Syntaxredistribute {bgp as number}{connected static}[metric metric- value metric-type type-value] [route-map map-name] [tag tag- value]

To disable redistribution, use the no redistribute {connected static} command.

Parameters

bgp as number

Enter the keyword bgp then the autonomous system

 

 

 

number.

 

 

The range is from 1 to 65535.

1164

Open Shortest Path First (OSPFv2 and OSPFv3)

Page 1164
Image 1164
Dell 9.7(0.0) manual Redistribute, Defaults Command Modes History Usage Information