set extcommunity bandwidth

Enables you to set extended community bandwidth.

Syntax

set extcommunity bandwidth

Parameters

Defaults

Command Modes

Command History

Usage Information

To disable extended community bandwidth, enter the no set extcommunity bandwidth command.

bandwidth

Enter the keyword bandwidth to enable extended

 

community bandwidth. The range is from 0 to 102400.

N/A

 

ROUTER MAP

 

VersionDescription

9.7(0.0)

Introduced on the S-Series.

A new policy command is introduced in order to attach the Link Bandwidth extended community only to the prefixes that are received from a neighbor that satisfy the desired conditions. This command is relevant for both inbound as well as outbound policy handling (for received prefixes). Also, there is no change to the set of supported conditions or filters.

During configuration, the bandwidth is specified in Mbps, not in bytes/second. While creating the actual LB extended community, the system will attach the AS number and encode the bandwidth in floating point format.

show capture bgp-pdu neighbor

Display BGP packet capture information for an IPv4 address on the system.

S6000

Syntax

show capture bgp-pdu neighbor ipv4-address

Parameters

ipv4-address

Enter the IPv4 address (in dotted decimal format) of the BGP

 

 

 

address to display packet information for that address.

Command

EXEC Privilege

 

Modes

 

 

Command

This guide is platform-specific. For command information about other platforms,

History

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

414

Border Gateway Protocol

Page 414
Image 414
Dell 9.7(0.0) manual Set extcommunity bandwidth, Show capture bgp-pdu neighbor ipv4-address