Dell 9.7(0.0) manual Dot1x auth-server, Vlan-id Enter the Vlan Identifier. The range is from 1 to

Parameters

Defaults

Command Modes

Command History

Usage Information

Related Commands

vlan-id Enter the VLAN Identifier. The range is from 1 to 4094.

max-attempts(OPTIONAL) Enter the keywords max-attemptsthen

numbernumber of attempts desired before authentication fails. The range is from 1 to 5. The default is 3.

3 attempts

CONFIGURATION (conf-if-interface-slot/port)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the C-Series, S-Series, and E-Series.

If the host responds to 802.1X with an incorrect login/password, the login fails. The switch attempts to authenticate again until the maximum attempts configured is reached. If the authentication fails after all allowed attempts, the interface is moved to the authentication failed VLAN.

After the authentication VLAN is assigned, the port-state must be toggled to restart authentication. Authentication occurs at the next re-authentication interval (dot1x reauthentication).

dot1x port-control — enables port-control on an interface.

dot1x guest-vlan — configures a guest VLAN for non-dot1x devices.

show dot1x interface — displays the 802.1X information on an interface.

dot1x auth-server

Configure the authentication server to RADIUS.

Syntax dot1x auth-server radius

Defaultsnone

Command CONFIGURATION

Modes

1410 Security