Parameters

Defaults

Command Modes

Command History

integer

Enter the number of consecutive misses before the LLDP

 

declares the interface dead. The range is from 2 to 10.

4 x hello

CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.7.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

7.4.1.0Introduced on the E-Series.

protocol lldp (Configuration)

Enable the LLDP globally on the switch.

S6000

Syntax

Defaults

Command Modes

Command History

protocol lldp

To disable LLDP globally on the chassis, use the no protocol lldp command.

Enabled.

CONFIGURATION (conf-lldp)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

Link Layer Discovery Protocol (LLDP)

961

Page 961
Image 961
Dell 9.7(0.0) manual Protocol lldp Configuration, Integer