Dell 9.7(0.0) manual Show config, Dellconf#router rip Dellconf-routerrip#

Usage Information

Example

Related Commands

VersionDescription

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

pre- 6.2.1.1 Introduced on the E-Series.

To enable RIP, assign a network address using the network command.

Dell(conf)#router rip

Dell(conf-router_rip)#

network — enables RIP.

exit — returns to CONFIGURATION mode.

show config

Display the changes you made to the RIP configuration. The default values are not shown.

S6000

Syntax	show config
Command	ROUTER RIP
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.
	The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

Routing Information Protocol (RIP) 1323