Dell 9.7(0.0) manual Line Beginning Description With Routing

Usage Information

Example

Related Commands

VersionDescription

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre- 6.1.1.1 Introduced on the E-Series.

If you delete all the network area commands for Area 0, the show ip ospf command output does not list Area 0.

The following describes the show ip ospf command shown in the following example.

Line Beginning	Description
with
“Routing	Displays the OSPF process ID and the IP address associated
Process...”	with the process ID.
“Supports only...”	Displays the number of Type of Service (TOS) rouse
	supported.
“SPF schedule...”	Displays the delay and hold time configured for this process
	ID.
“Convergence
Level”
“Min LSA....”	Displays the intervals set for LSA transmission and
	acceptance.
“Number of...”	Displays the number and type of areas configured for this
	process ID.

Dell#show ip ospf 10

Routing Process ospf 10 with ID 1.1.1.1 Virtual router default- vrf

Supports only single TOS (TOS0) routes

SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Convergence Level 0

Min LSA origination 0 msec, Min LSA arrival 1000 msec Min LSA hold time 5000 msec, Max LSA wait time 5000 msec Number of area in this router is 1, normal 1 stub 0 nssa 0

Area BACKBONE (0)

Number of interface in this area is 1 SPF algorithm executed 205 times Area ranges are

Dell#

show ip ospf database — displays information about the OSPF routes configured.

show ip ospf interface — displays the OSPF interfaces configured. show ip ospf neighbor — displays the OSPF neighbors configured.

Open Shortest Path First (OSPFv2 and OSPFv3) 1105