Usage Information

Example

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

9.0.0.0Introduced on the Z9000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Introduced on the S4810. Added support for source- interface for link-local IPv6 addressing.

8.3.11.1Introduced on the Z9000.

8.2.1.0Introduced on the E-Series ExaScale (IPv6). Increased the number of VLANs on ExaScale to 4094 (was 2094).

8.1.1.0Introduced on the E-Series ExaScale (IPv4).

7.9.1.0Introduced VRF.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series and added support for IPv6 address on the E-Series only.

The VRF configured using this command has a higher precedence than a VRF configured using the ip telent vrf vrf-namecommand. If you do not use the VRF attribute in this command, then TELENT client uses the VRF configured using the ip telnet vrf vrf-namecommand.

The source interface configured using this command has a higher precedence than the source interface configured using the ip telent source-interfacecommand. If you do not configure a source interface using this command, then the TELNET client uses the source interface configured using the ip telent source-interfacecommand.

In case there is a mismatch between the VRF telnet source interface and the telent VRF, then an error is reported.

Dell#telnet vrf vrf1 10.10.10.2

telnet-peer-stack-unit

Open a Telnet connection to the peer stack unit.

Syntax

telnet-peer-stack-unit

Defaults

Not configured.

Command

• EXEC

Modes

 

Control and Monitoring

153

Page 153
Image 153
Dell 9.7(0.0) manual Telnet-peer-stack-unit, Dell#telnet vrf vrf1, Defaults Not configured Command