Dell 9.7(0.0) manual Offset-list

Usage Information

VersionDescription

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

pre- 6.2.1.1 Introduced on the E-Series.

You can enable an unlimited number of RIP networks.

RIP operates over interfaces configured with any address the network command specifies.

offset-list

Specify a number to add to the incoming or outgoing route metrics learned using RIP.

S6000

Syntaxoffset-listprefix-list-name {in out} offset [interface]

To delete an offset list, use the no offset-listprefix-list-name{in

out} offset [interface] command.

Parameters	prefix-list-	Enter the name of an established Prefix list to determine
	name	which incoming routes are modified.
	offset	Enter a number from zero (0) to 16 to be applied to the
		incoming route metric matching the access list specified. If
		you set an offset value to zero (0), no action is taken.
	interface	(OPTIONAL) Enter the following keywords and slot/port or
		number information:
		• For a Port Channel interface, enter the keywords port-
		channel then a number. The range is from 1 to 128.
		• For a 10-Gigabit Ethernet interface, enter the keyword
		TenGigabitEthernet then the slot/port information.
		• For a 40-Gigabit Ethernet interface, enter the keyword
		fortyGigE then the slot/port information.
		• For a VLAN, enter the keyword vlan then a number from
		1 to 4094.
Defaults	Not configured.
Command	ROUTER RIP
Modes

1316 Routing Information Protocol (RIP)