Related Commands

bgp client-to-client reflection — enables route reflection between the route reflector and clients.

neighbor route-reflector-client — configures a route reflector and clients. show ip bgp cluster-list — views paths with a cluster ID.

bgp confederation identifier

Configure an identifier for a BGP confederation.

S6000

Syntax

bgp confederation identifier as-number

Parameters

Defaults

Command Modes

Command History

Usage Information

To delete a BGP confederation identifier, use the no bgp confederation identifier as-numbercommand.

as-number

Enter the AS number. The range is from 0 to 65535 (2 byte),

 

from 1 to 4294967295 (4 byte), or from 0.1 to 65535.65535

 

(dotted format).

Not configured.

 

ROUTER BGP

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series. Added support for the 4-byte format

To accept 4-byte formats before entering a 4-byte AS number, configure your system. All the routers in the Confederation must be 4 byte or 2 byte identified routers. You cannot mix them.

348

Border Gateway Protocol

Page 348
Image 348
Dell 9.7(0.0) manual Bgp confederation identifier as-number, As-number