Dell 9.7(0.0) manual IP Prefix List Commands, Clear ip prefix-list prefix-name, Prefix-name

Usage Information

Related Commands

VersionDescription

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

7.4.1.0Added the monitor option.

6.1.1.0Introduced on the E-Series.

When you use the log option, the CP processor logs details about the packets that match. Depending on how many packets match the log entry and at what rate, the CP may become busy as it has to log these packets’ details.

NOTE: When you configure the ACL logging and byte counters simultaneously, byte counters may display an incorrect value. Configure packet counters with logging instead.

deny — configures a MAC ACL filter to drop packets.

seq — configure a MAC ACL filter with a specified sequence number.

IP Prefix List Commands

When you create an access-list without any rule and then apply it to an interface, the ACL behavior reflects implicit permit.

To configure or enable IP prefix lists, use these commands.

clear ip prefix-list

Reset the number of times traffic mets the conditions (“hit” counters) of the configured prefix lists.

Syntax	clear ip prefix-list [prefix-name]
Parameters	prefix-name	(OPTIONAL) Enter the name of the configured prefix list to
		clear only counters for that prefix list, up to 140 characters
		long.
Defaults	Clears “hit” counters for all prefix lists unless a prefix list is specified.
Command	EXEC Privilege
Modes
Command	This guide is platform-specific. For command information about other platforms,
History	refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Access Control Lists (ACL) 237