maximum dynamic-routes-ipv6

Specify the maximum number of dynamic (protocol) IPv6 routes a VRF can have.

S6000

Syntax

Parameters

Defaults

Command Modes

Command History

Usage Information

maximum dynamic-routes—ipv6 limit {warn-thresholdthreshold-value

warning-only}

To remove the limit on the maximum number of IPv6 routes used, use the no maximum dynamic-routes-ipv6command.

limit

Maximum number of IPv6 routes allowed in a VRF. Valid

 

range is from 1 to 8000 (or maximum allowable for that

 

platform if smaller value).

warning-

Warning threshold value is expressed as a percentage of the

threshold

limit value. When the number of IPv6 routes reaches the

 

specified percentage of the limit, a warning message is

 

generated. Valid range is 1 to 100. When warn-threshold is

 

used, once the limit is reached, additional routes will not be

 

allowed into the RTM ( route table manager ) itself.

warning-only

When the warning-only option is used, a syslog message will

 

be thrown when maximum number of dynamic IPv6 routes

 

reaches the limit. Additional dynamic IPv6 routes will still be

 

allowed.

No limit is set on the maximum number of dynamic IPv6 routes for a VRF.

CONFIGURATION-VRF

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OSCommand Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S4810, S4820T, S5000, S6000, S6000-

 

ON, and Z9500.

If the maximum IPv6 route limit is not specified for a VRF (valid range is from 1 to 8000), then it has unlimited space that extends to the maximum number of entries allowed for the system. This command is not applicable to the default and management VRFs.

820

IPv6 Basics

Page 820
Image 820
Dell 9.7(0.0) manual Maximum dynamic-routes-ipv6, Limit