Dell 9.7(0.0) manual Syntaxdistance weight ip-address mask prefix-name

Defaults

Command Modes

Command History

Related Commands

none

ROUTER RIP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.6.1.0Introduced on the C-Series.

pre- 7.7.1.0 Introduced on the E-Series.

router rip — enters ROUTER mode on the switch.

distance

Assign a weight (for prioritization) to all routes in the RIP routing table or to a specific route. Lower weights (“administrative distance”) are preferred.

S6000

Syntaxdistance weight [ip-address mask [prefix-name]]

To return to the default values, use the no distance weight [ip-address mask] command.

Parameters	Enter a number from 1 to 255 for the weight (for
weight
	prioritization). The default is 120.
ip-address	(OPTIONAL) Enter the IP address, in dotted decimal format
	(A.B.C.D), of the host or network to receive the new distance
	metric.
mask	If you enter an IP address, also enter a mask for that IP
	address, in either dotted decimal format or /prefix format
	(/x).

1306 Routing Information Protocol (RIP)