max-area-addresses

Configure manual area addresses.

Syntax

Parameters

Defaults

Command Modes

Command History

max-area-addresses number

To return to the default values, use the no max-area-addressescommand.

number

Set the maximum number of manual area addresses. The

 

range is from 3 to 6. The default is 3.

3addresses

ROUTER ISIS

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.12.0Introduced on the S4810.

8.3.11.1Introduced on the Z9000.

7.5.1.0Added support for LSP Throttling Enhancement.

Usage

To configure the number of area addresses on router, use this command. This

Information

value must be consistent with routers in the same area, otherwise the router forms

 

only Level 2 adjacencies. The value must be same among all the routers to form

 

Level 1 adjacencies.

max-lsp-lifetime

Set the maximum time that link-state packets (LSPs) exist without being refreshed.

Syntax

Parameters

max-lsp-lifetime seconds

To restore the default time, use the no max-lsp-lifetimecommand.

seconds

The maximum lifetime of LSP in seconds. This value must be

 

greater than the lsp-refresh-intervalcommand. The

 

higher the value the longer the LSPs are kept. The range is

 

from 1 to 65535. The default is 1200.

882

Intermediate System to Intermediate System (IS-IS)

Page 882
Image 882
Dell 9.7(0.0) manual Max-area-addresses number, Max-lsp-lifetime seconds