Parameters

Default

Command Modes

Command History

Usage Information

value

To configure the primary role on a VLT peer, enter a lower

 

value than the priority value of the remote peer. The range is

 

from 1 to 65535.

32768

 

VLT DOMAIN

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.5(0.0)

Introduced on the Z9500.

9.2(0.0)

Introduced on the M I/O Aggregator. This command is

 

supported in Programmable-Mux (PMUX) mode only.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.8.0Introduced on the S4810.

After you configure the VLT domain on each peer switch on both sides of the interconnect trunk, by default, the Dell Networking OS software elects a primary and secondary VLT peer device. To reconfigure the primary role of VLT peer switches, use the priority command.

show vlt brief

Displays summarized status information about VLT domains currently configured on the switch.

Syntax

show vlt brief

Default

Not configured.

Command

EXEC

Modes

 

Command

This guide is platform-specific. For command information about other platforms,

History

refer to the relevant Dell Networking OS Command Line Reference Guide.

 

The following is a list of the Dell Networking OS version history for this command.

1634

Virtual Link Trunking (VLT)

Page 1634
Image 1634
Dell 9.7(0.0) manual Show vlt brief