Parameters

Command Modes

Command History

Usage Information

vrf vrf-name

(OPTIONAL) Enter the keyword vrf followed by the name of

 

the VRF to display BGP state changes corresponding to that

 

VRF.

A.B.C.D

(OPTIONAL) Enter the IPv4 address of the neighbor.

X:X:X:X::X

(OPTIONAL) Enter an IPv6 address.

peer-group

(OPTIONAL) Enter the keyword peer-groupthen the name

peer-group-

of the peer group.

name

 

in

(OPTIONAL) Enter the keyword in to view only events on

 

inbound BGP messages.

out

(OPTIONAL) Enter the keyword out to view only events on

 

outbound BGP messages.

EXEC Privilege

 

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0)

Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

To remove all configured debug commands for BGP, enter the no debug ip bgp command.

debug ip bgp keepalives

Display information about BGP keepalive messages.

S6000

Syntaxdebug ip bgp [vrf vrf-name] [A.B.C.D X:X:X:X::X peer-group peer-group-name] keepalives [in out]

Border Gateway Protocol

371

Page 371
Image 371
Dell 9.7(0.0) manual Debug ip bgp keepalives, Parameters Command Modes Command History Usage Information