VersionDescription

8.5.1.0Added support for 4-port 40G line cards on ExaScale.

6.2.1.1Introduced

ip msdp peer

Configure an MSDP peer.

S6000

Syntaxip msdp peer peer address [connect-source] [description] [sa- limit number]

Parameters

Defaults

Command Modes

Command History

To remove the MSDP peer, use the no ip msdp peer peer address [connect-source interface] [description name] [sa-limitnumber] command.

peer address

Enter the peer address in a dotted decimal format (A.B.C.D.).

connect-

Enter the keywords connect-sourcethen one of the

source

interfaces and slot/port or number information:

interface

• For a 10-Gigabit Ethernet interface, enter the keyword

 

 

TenGigabitEthernet then the slot/port information.

 

• For a 40-Gigabit Ethernet interface, enter the keyword

 

fortyGigE then the slot/port information.

 

• For a Loopback interface, enter the keyword loopback

 

then a number from 0 to 16383.

 

• For a port channel interface, enter the keywords port-

 

channel then a number. The range is from 1 to 128.

 

• For a VLAN interface, enter the keyword vlan then a

 

number from 1 to 4094.

description

(OPTIONAL) Enter the keyword description then a

name

description name (maximum 80 characters) to designate a

 

description for the MSDP peer.

sa-limit

(OPTIONAL) Enter the maximum number of SA entries in SA-

number

cache. The range is from 1 to 100000. .

As described in the Parameters section.

CONFIGURATION

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

986

Multicast Source Discovery Protocol (MSDP)

Page 986
Image 986
Dell 9.7(0.0) manual Ip msdp peer, Connect, Sa-limit