Dell 9.7(0.0) manual Neighbor fall-over, Usage

VersionDescription

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

Usage	To prevent loops, the neighbor ebgp-multihopcommand does not install the
Information	default routes of the multihop peer. Networks not directly connected are not
	considered valid for best-path selection.

neighbor fall-over

Enable or disable fast fall-over for BGP neighbors.

S6000

Syntaxneighbor {ipv4-address peer-group-name}fall-over

Parameters

Defaults

Command Modes

Command History

To disable, use the no neighbor {ipv4-address peer-group-name} fall-over command.

ipv4-address	Enter the IP address of the neighbor in dotted decimal
	format.
peer-group-	Enter the name of the peer group.
name
Disabled.
ROUTER BGP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

VersionDescription

9.7(0.0) Introduced on the S6000–ON.

9.0.2.0Introduced on the S6000.

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.8.1.0Introduced on the S-Series.

7.7.1.0Introduced on the C-Series.

388 Border Gateway Protocol