Dell 9.7(0.0) manual Match ip route-source

Related Commands

VersionDescription

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

8.1.1.0Introduced on the E-Series ExaScale.

7.8.1.0Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long.

7.6.1.0Introduced on the S-Series.

7.5.1.0Introduced on the C-Series.

pre-6.1.1.0 Introduced on the E-Series.

match interface — redistributes routes that match the next-hop interface.

match ip address — redistributes routes that match an IP address.

match ip route-source — redistributes routes that match routes advertised by other routers.

match metric — redistributes routes that match a specific metric.

match route-type — redistributes routes that match a route type.

match tag — redistributes routes that match a specific tag.

match ip route-source

To match based on the routes advertised by routes specified in IP access lists or IP prefix lists, configure a filter.

Syntaxmatch ip route-source {prefix-list prefix-list-name}

To delete a match, use the no match ip route-source {prefix-list prefix-list-name} command.

Parameters

Defaults

Command Modes

Command History

prefix-list	Enter the keywords prefix-listand then enter the name
prefix-list-	of configured prefix list, up to 140 characters.
name
Not configured.
ROUTE-MAP

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Access Control Lists (ACL) 251