Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux (PMUX) mode only.

Parameters

Defaults

Command Modes

Command History

Usage Information

packets_per_se

Enter the packets per second of multicast traffic allowed into

cond in

the network. The range is from 0 to 33554368.

none

CONFIGURATION (conf)

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version

Description

9.7(0.0)

Introduced on the S6000-ON.

9.0.2.0Introduced on the S6000.

9.2(0.0)

8.3.19.0Introduced on the S4820T.

8.3.11.1Introduced on the Z9000.

8.3.7.0Introduced on the S4810.

7.6.1.0Introduced on the C-series and S-Series.

Broadcast traffic (all 0xFs) should be counted against the broadcast storm control meter, not against the multicast storm control meter. It is possible, however, that some multicast control traffic may get dropped when storm control thresholds are exceeded.

storm-control multicast (Interface)

Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only) network only.

Syntax

storm-control multicast packets_per_second in

 

To disable multicast storm control on the interface, use the no storm-control

 

multicast packets_per_second in command.

Parameters

packets_per_se

Enter the packets per second of broadcast traffic allowed

 

 

cond in

into the network. The range is from 0 to 33554368.

Defaults

none

 

Storm Control

1547

Page 1547
Image 1547
Dell 9.7(0.0) manual Storm-control multicast Interface, Parameters